Subaru 2007 Tribeca - Manual (Page 240)

Starting and operating
7-11
7
– CONTINUED –
the brake pedal repeatedly will toggle the
feature ON or OFF each time.
7. To exit the remote transmitter and fea-
ture programming mode, turn the ignition
switch to the “OFF” position, remove the
key from the ignition switch and test oper-
ation of the remote transmitter(s) and horn
confirmation feature.
„ System maintenance
T Changing the remote control batter-
ies
The two 3-volt lithium batteries (model
CR-1220) supplied in your remote control
should last approximately three years, de-
pending on usage. When the batteries be-
gin to weaken, you will notice a decrease
in range (distance from the vehicle that
your remote control operates). Follow the
instructions below to change the remote
control batteries.
1. Carefully pry the remote control halves
apart using a small flathead screwdriver.
2. Remove the circuit board from the bot-
tom half of the case and slide the white
plastic battery holder out from under the
battery tab releasing the batteries. Re-
move the old batteries and replace with
new ones. Be sure to observe the (+) sign
700389
700390
700391
700392
CR-1220
+
CR-1220
+
A3120BE-B.book 11 ページ ２００６年５月３０日 火曜日 午前９時３２分