Subaru 2007 Tribeca - Manual (Page 60)

Seat, seatbelt and SRS airbags
1-35
1
– CONTINUED –
T Installing a rearward facing child re-
straint
1. Slide the seat or seat pair to its rear-
most position.
2. Adjust the seatback to the upright posi-
tion.
3. Place the child restraint system in the
rear seating position.
4. Run the lap and shoulder belt through
or around the child restraint system follow-
ing the instructions provided by its manu-
facturer.
5. Insert the tongue plate into the buckle
until you hear a click.
6. Take up the slack in the lap belt.
7. Pull out the seatbelt fully from the re-
tractor to change the retractor over from
the Emergency Locking Retractor (ELR)
to the Automatic Locking Retractor (ALR)
function. Then, allow the belt to rewind
into the retractor. As the belt is rewinding,
clicks will be heard which indicate the re-
tractor functions as ALR.
8. Push and pull the child restraint system
forward and from side to side to check if it
is firmly secured.
Sometimes a child restraint can be more
firmly secured by pushing it down into the
seat cushion and then tightening the seat-
belt.
9. Pull at the shoulder portion of the belt
to confirm that it cannot be pulled out (ALR
properly functioning).
100503
100504 100505
A3120BE-B.book 35 ページ ２００６年５月３０日 火曜日 午前９時３２分