Subaru 2007 Tribeca User Manual

Page 166

Advertising
background image

Climate control

4-5

4

CONTINUED

Automatic climate control

system

NOTE

y

Operate the automatic climate con-

trol system when the engine is run-

ning.
y

The blower fan rotates at a low speed

when the engine coolant temperature

is low.

For efficient defogging or dehumidify-

ing in cold weather, press the “A/C”

button.
y

Even when cooling is not necessary,

setting the temperature much lower

than the current outlet air temperature

turns on the air conditioner compres-

sor automatically and the “A/C” indica-

tor light on the control panel comes on.
y

Seven-seater models each have a

rear air conditioner. The fan speed of

the rear air conditioner can be adjust-

ed, but other adjustments (outlet air

temperature, air distribution, etc.) are

not possible for the rear air condition-

er. For details, refer to “Rear air condi-

tioner (if equipped)” in this section.

The automatic climate control system au-

tomatically controls outlet air temperature,

fan speed, air flow distribution air-inlet

control, and air conditioner compressor

operation. It activates when the “AUTO”

button is pressed, and is used to maintain

a constant, comfortable climate within the

passenger compartment.

The temperature can be set within a range

of 65 to 85

°F (18 to 32°C).

„

Control panel

1) Temperature control dial (driver’s side)

2) Defroster button

3) Fan speed control dial

4) Rear window defogger button (Refer to

the “Rear window defogger button” in

chapter 3.)

5) Temperature control dial (passenger’s

side)

6) Air conditioner button

7) Air flow mode selection button

8) Air inlet selection button

9) OFF button

10)AUTO button

T AUTO button
AUTO mode operation:

When the “AUTO” button is pressed, the

indicator light on the button comes on. In

this state, fan speed, air flow distribution,

air-inlet control, and air conditioner com-

pressor operation are automatically con-

trolled.

Manual mode operation:

If you operate any of the buttons on the

control panel other than the “OFF” button

and temperature control dial during auto-

matic mode operation, the indicator light

will go out. You can then manually control

the system as desired using the button

you operated.

1

10 9

8

7

6

2

3

4

5

400506

400507

A3120BE-B.book 5 ページ 2006年5月30日 火曜日 午前9時32分

Advertising