Subaru 2007 Tribeca User Manual

Page 192

Advertising

5-19

– CONTINUED –

road or inside of a parking garage.

To help reduce this condition, satellite ra-

dio providers have installed ground-based

repeaters in heavily populated areas.

However, you may still experience recep-

tion problems in some areas.

V Band selection button
Push the “SAT” button (1) when the radio

is off to turn on the radio.

Push the “SAT” button when the radio is

on to select SAT1, SAT2 or SAT3 recep-

tion.

V Channel selection
Press “

” of the TUNE TRACK button

(4) to select the next channel and press

“

” of the button to select the previous

channel.

Keep pressing “

” of the button to

change to the next channel continuously

and keep pressing “

” of the button to

change to the previous channel continu-

ously.

V Category selection
Press “

” or “

” of the SEEK FLDR

button (7) to display the current category.

Press “

” again to select the next cate-

gory, and press “

” again to select the

previous category.

V Channel scan
Press the “SCAN” button (8) to change the

radio to the SCAN mode. In this mode, the

radio scans through the channels until a

station is found. The radio will stop at the

station for five seconds while displaying

the channel number, after which scanning

will continue until the entire channel has

been scanned from the low end to the high

end.

Also during the category selection, chan-

nel scan can be performed in that catego-

ry.

Press the “SCAN” button again to cancel

the SCAN mode and to stop on any dis-

played channel.

V Selecting preset channels
Presetting a channel with a preset button

(10) allows you to select that channel in a

single operation. Up to six, SAT1, SAT2

and SAT3 channels each may be preset.

V How to preset channels
1. Press the “SAT” button (1) to select

SAT1, SAT2 and SAT3 reception.

2. Press the “SCAN” button (8) or the

TUNE TRACK button (4) to select the

channel.

3. Press one of the preset buttons (10) for

more than 1.5 seconds to store the chan-

nel. If the button is pressed for less than

1.5 seconds, the preceding selection will

remain in memory.

NOTE

If the connection between the radio

and battery is broken for any reason

such as vehicle maintenance or radio

removal, all channels stored in the pre-

set buttons are cleared. If this occurs,

it is necessary to reset the preset but-

tons.

V Display selection
Press the “AUDIO” (5) button while receiv-

ing satellite radio to change the display as

follows:

T Rear seat entertainment
If your vehicle is equipped with a Rear

Seat Entertainment System, you can en-

joy audio outputs from the system through

the vehicle’s speakers by pressing the

“RSE AUX” button. Press the button again

to return to the audio set sound.

CHANNEL