Subaru 2007 Tribeca - Manual (Page 150)

Instruments and controls
3-27
3
ment panel is also on.
To switch back to low beam, pull the lever
back to the detent position.
„ Headlight flasher
To flash the headlights, pull the lever to-
ward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works
even though the light switch is in the
“OFF” position.
When the headlights are on high beam,
the high beam indicator light “ ” on
the instrument panel also comes on.
„ Daytime running light system
The front side marker lights, parking
lights, tail lights and license plate lights will
automatically come on and the low beam
headlights will automatically come on at
reduced brightness when the engine has
started, under the following conditions:
y
The parking brake is fully released.
y The light switch is in the “OFF” or
“ ” position.
The indicator light located on the combi-
nation meter will illuminate when the day-
time running light system is on.
Turn signal lever
To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatically. If the lever does
not return after cornering, return the lever
to the neutral position by hand.
To signal a lane change, push the turn sig-
nal lever up or down slightly and hold it
during the lane change. The turn signal in-
dicator lights will flash in the direction of
the turn or lane change. The lever will re-
turn automatically to the neutral position
when you release it.
Do not hold the lever in the flashing
position for more than just a few
seconds.
300508
The brightness of the illumination of
the low beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the “ ” position when
it is dark outside.
300509
A3120BE-B.book 27 ページ ２００６年５月３０日 火曜日 午前９時３２分