CIRCUTOR DISPENSER Series - Manual (Page 77)

5�- DISPENSER UNIVERSAL
5.1.- INSTALLATION OF THE UNIT
5�1�1�- PRELIMINARY RECOMMENDATIONS
In order to use the unit safely, it is critical that individuals who handle it follow
the safety measures set out in the standards of the country where it is being
used, use the personal protective equipment necessary, and pay attention to the
various warnings indicated in this instruction manual.
The unit must be installed by authorised and qualified staff.
The power supply must be disconnected before handling, altering the connections or replacing
the unit. It is dangerous to handle the unit while it is powered.
Also, it is critical to keep the cables in perfect condition to avoid accidents, personal injury and
damage to installations.
The manufacturer of the unit is not responsible for any damage resulting from failure by the
user or installer to heed the warnings and/or recommendations set out in this manual, nor for
damage resulting from the use of products or accessories that did not come with the unit or that
were made by other manufacturers.
If an anomaly or malfunction is detected in the unit, do not use the unit to take any measure-
ments.
Inspect the work area before taking any measurements. Do not take measurements in danger-
ous areas or where there is a risk of explosion.
Disconnect the unit from the power supply (unit and measuring system power
supply) before maintaining, repairing or handling the unit's connections.
Please contact the after-sales service if you suspect that there is an operational
fault in the unit.
5�1�2�- INSTALLATION
Terminals, opening roofs or removing elements can expose parts that are haz-
ardous to the touch while the unit is powered. Do not use the unit until it is fully
installed.
To access the unit terminals you need to remove the front cover at the bottom of the unit, the
wire cover lid.
The Dispenser has a sensor that detects the opening and closing of the wire cover lid. This
detection is always performed, even when the Dispenser has no power supply.
The connection terminal screws are of the mixed type, allowing the use of PZ2 (Pozi drive no.
2) screwdrivers.
77 Instruction Manual
Dispenser Universal System