Axel AX3000 65 User's Manual - firmware 0632 - Manual (Page 151)

Installing under OS/400
AX3000 - User's Manual
137
The supported resources are:
- Screen sessions: SESS1, SESS2...
- Auxiliary ports: AUX1, AUX2, PARALLEL, NETx and USBx.
Use the following command to reset a resource:
===> RUNRMTCMD CMD('AX_SINIT password RESS') RMTLOCNAME('192.1.1.241' *IP)
Where:
- AX_REBOOT : Command for AX3000 resource reset,
- password
: Specify the set-up password if set,
- 192.1.1.241 : AX3000 IP address.
- RESS
: Resource name (ex: SESS1).
c) Editing the AX3000 Settings
The whole AX3000 set-up can be obtained by invoking the following command:
===> RUNRMTCMD CMD(SETUP_GET) RMTLOCNAME('192.168.1.241' *IP)
or a partial set-up can also be obtained (only used set-up parameters are sent):
===> RUNRMTCMD CMD(SETUP_GET_LITE) RMTLOCNAME('192.168.1.241' *IP)
Where:
- SETUP_GET : Command for getting the whole set-up,
- SETUP_GET_LITE : Command for getting the partial set-up,
- 192.168.1.241
: AX3000 IP address.
For more information about these commands, refer to Chapter 10.
d) Setting-Up the AX3000
No OS/400 command allows the contents of a set-up file to be sent over the
network. The following example describes the use of rsh Windows command:
c:\> rsh 192.168.1.241 setup_send password < /tmp/axel
Where:
- 192.168.1.241 : AX3000 IP address,
- setup_send
: Command for set-up the AX3000,
- password : Specify the set-up password if set.