Becker TRAFFIC ASSIST PRO Z302 - Manual (Page 47)

47
NAVIGATION MODE >>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
If the route guidance is already running
you will be asked whether the new desti-
nation should replace the old destination
or if the new destination should be regard-
ed as a waypoint.
> Select Add as stopover or Replace old
destination .
If the route guidance is already running
and a waypoint has already been entered
you will be asked whether the new desti-
nation should replace the old destination
or the waypoint.
> Select Replace stopover or Replace
old destination .
Note:
The symbols above the progress bar refer
to restrictions that you may have acti-
vated (e. g. unpaved roads, toll roads).
The symbol
next to the progress bar
indicates that the time-dependent route
guidance described in “The Route op-
tions button” on page 61 is active.
Note:
If there is no GPS signal when the route
is calculated, the following will be dis-
played:
When a GPS signal is available, the route
calculation will start automatically.
When the
Last position button is
pressed, the last known position is used
and the route calculated from this posi-
tion.