Datalogic Scanning POWERSCAN 7000 - Manual (Page 11)

LED and Beeper Indications
Product Reference Guide 1-3
LED and Beeper Indications
The imager is equipped with a beeper (speaker) and two indicator LEDs;
one green and one yellow. These indicators “beep” or flash when certain
actions take place:
NOTE
Some LED and Beeper indications are user-con-
figurable for volume, pitch, quantity, duration,
enable/disable, etc. Those listed in the following
table assume the feature is enabled. See the
Product Reference Guide (PRG) for detailed pro-
gramming information.
Condition Green LED Beeper
Powering On
UKBW/RS-232 Models
(using UKBW interface)
2 normal flashes and 2 fast flashes
(+ 1 normal flash with Smart cable)
One Beep
Powering On
UKBW/RS-232 Models
(using RS-232 interface)
2 normal flashes and 1 long flash One Beep
Powering On
All Other Models
Bright Green Flash One Beep
Good Read 1 - 9 Bright Green Flash(es)
a
a. Good Read indications are synchronous. That is, if Good Read beeps
are set via programming to five (for example), the Good Read LED will
also flash five times.
1 - 9 Beep(s) a
Error Indication Green Flash Special Beep
Condition Yellow LED Beeper
Ready to Operate Yellow LED on steady until trigger is pulled None