Datalogic Scanning POWERSCAN 7000 - Manual (Page 142)

OCR Programming
8-12 PowerScan ® 7000 2D
OCR User-Defined Check Character
You can customize the check character calculation to suit your applica-
tion. Each character of the check character alphabet can be programmed
in its proper order. The number of characters you enter determines the
modulo value for the calculation. By default, the check character com-
putation is unweighted, but the imager also supports two weighted mod-
ulo 10 checking schemes.
Example: To program a modulo 11 check character, you would enter the following 11
characters in order:
0123456789X
Also enter the OCR template:
dddddddc
Enable the OCR-A font, then scan the following string:
6512351X
The imager performs the following check character computation:
(6 + 5 + 1 + 2 +3 + 5 + 1 + X) modulo 11 = 0
Since the result is zero, the message is considered to be valid, so the
reader outputs the message: 6512351
Programming a User-Defined Check Char-
acter
1. Scan the Enter OCR Check Character bar code, below.
2. Enter the characters in order. For each character, look up the cor-
responding hex value from the ASCII Conversion Chart (Code Page
1252) on page A-4 . Use the Programming Chart on page B-5 of this
manual to scan the two symbols for each hex value.
3. Scan the Save bar code on the Programming Chart on page B-5 .
Example: To program the modulo 11 check character from example #8 on page 8-12 ,
enable the OCR-A font. Scan the Enter OCR Check Character bar code on
page 8-12 , then scan the following hex values in order:
3031323334353637383958
Enter OCR Check Character