Datalogic Scanning POWERSCAN 7000 - Manual (Page 41)

Illumination Lights
Product Reference Guide 3-11
Illumination Lights
If you want the illumination lights on while reading a bar code, scan the
Lights On bar code, below. However, if you want to turn just the lights
off, scan the Lights Off bar code.
Imager Time-Out
Imager Time-Out powers down the imager after the unit has been idle
for the specified time. To prevent the imager from powering down, set
this time-out to 0. Scan the bar code below, then set the time-out by
scanning digits (from 0 - 999,999 ms) from the
Programming Chart on
page B-5 , then scanning Save. Default = 120,000 ms.
NOTE
This setting does not affect the aimer light. The
aiming light can be set using Aimer Mode (see
Aimer Modes on page 3-13 ).
Lights Off
* Lights On
Imager Time-Out