Datalogic Scanning POWERSCAN 7000 - Manual (Page 42)

Output
3-12 PowerScan ® 7000 2D
Aimer Delay
The aimer delay allows a delay time for the operator to aim the imager
before the picture is taken. Use these codes to set the time between when
the trigger is pulled and when the picture is taken. During the delay
time, the aiming light will appear, but the LEDs won’t turn on until the
delay time is over.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the
bar code below, then set the time-out by scanning digits (0 - 4,000 ms)
from the
Programming Chart on page B-5 of this manual, then scan Save.
400 milliseconds
* Off (no delay)
200 milliseconds
Delay Duration