Datalogic Scanning POWERSCAN 7000 - Manual (Page 20)

Terminal Interfaces
2-2 PowerScan ® 7000 2D
For example, an IBM AT terminal has a Terminal ID of 003. You would
scan the
Terminal ID bar code, then 0 , 0 , 3 from the Programming Chart on
page B-5 of this manual, then Save . If you make an error while scanning
the digits (before scanning Save), scan the Discard code marked Discard
on page B-4 , scan the Terminal ID bar code, scan the digits, and the Save
code again.
NOTE
After scanning one of these codes, you must
power cycle your computer.
Supported Terminals
Terminal Model(s) Terminal ID
IBM SurePOS USB Hand Held Imager 128
a
a. Applies to USB models only. It is best to use the Plug and Play bar
codes located in the Quick Reference Guide, to program these inter-
faces, rather than scanning the terminal ID listed in this table.
IBM SurePOS USB Tabletop Imager 129
a
RS-232 True 000
b
b. Default for RS-232 models
RS-232 TTL 000
Serial Wedge 050
USB COM Port Emulation 130
a
USB PC Keyboard 124
a
USB Mac Keyboard 125
a
USB HID POS 131
a
Terminal ID
Save