Datalogic Scanning POWERSCAN 7000 - Manual (Page 12)

Getting Started
1-4 PowerScan ® 7000 2D
Plug and Play
Plug and Play bar codes provide instant imager set up for commonly
used interfaces.
Connecting the imager with an RS-232
Serial Port
1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the imager.
NOTE
After you scan one of the codes, power cycle
the host terminal to have the interface in effect.
NOTE
These instructions are for use with the RS-232
cable. This includes both Power Off the Termi-
nal (P.O.T.) and external power.
NOTE
For the imager to work properly, you must have
the correct cable for your type of terminal/com-
puter.
Captive
Screws
Retainer Boss
Cable Connector
For 220-230 VAC
adapters, the
cord must be
facing down as
shown in the
illustration. If
installed upwards,
it will pose an
undue strain on the
socket outlet.