Marantz SR6006 - Manual (Page 103)

100
Audio Adjust
n Surround Parameters
Default settings are underlined.
The items (parameters) that can be adjusted depend on the signal being input and the currently
set surround mode. For details on the adjustable parameters, see “Surround modes and surround
parameters” (
vpage 137 ).
NOTE
• Some setting items cannot be set while playback is stopped. Make the settings during playback.
• You cannot set the surround parameters in the PURE DIRECT mode.
Setting items Setting details
HT-EQ
Soften the treble range
of movie soundtracks for
better understanding. ON : “HT-EQ” is used.
OFF : “HT-EQ” is not used.
• Buttons on the remote control unit can be used
for operations.
q
Press AMP to set the remote control unit to
AMP-operation mode.
w Press HT-EQ .
DRC
Compress dynamic range
(difference between loud
and soft sounds). Auto : Automatic dynamic range compression on/off control according to
source. This can be set in the Dolby TrueHD mode.
Low / Middle / High : These set the compression level.
OFF : Dynamic range compression always off.
D.COMP
Compress dynamic range
(difference between loud
and soft sounds). OFF : Turn dynamic range compression off.
Low / Middle / High : These set the compression level.
LFE
Adjust the low-frequency
effects level (LFE). –10dB – 0dB
For proper playback of the different sources, we recommend setting
to the values below.
• Dolby Digital sources : “0dB”
• DTS movie sources : “0dB”
• DTS music sources : “–10dB”
AUDIO/VIDEO ADJUST
Setting items Setting details
Center Image
Assign center channel
signal to front left and right
channels for wider sound. 0.0 – 1.0 (0.3)
Panorama
Assign front L/R signal also
to surround channels for
wider sound. ON : Set.
OFF : Do not set.
Dimension
Shift sound image center
to front or rear to adjust
playback balance. 0 – 6 (3)
Center Width
Assign center channel
signal to front left and right
channels for wider sound. 0 – 7 (3)
Height Gain
Control the front height
channel volume. Low : Reduce the front height channel volume.
Middle : Front height channel sound is output with standard sound
volume.
High : Increase the front height channel volume.
NOTE
“Height Gain” is displayed for the following settings.
• When the “Speaker Config.” – “Front Height” setting (
vpage 107 ) is
set other than to “None”.
• When surround mode is “PL gz” or the PLgz decoder is used.
Default
The “Surround Parameters”
settings are returned to the
default settings. Yes : Reset to the defaults.
No : Do not reset to the defaults.
When you select “Default” and press ENTER ,
the “Return all settings to the default?”
prompt is displayed. Select either “Yes” or
“No”, and press
ENTER .
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
BD