Marantz SR6006 - Manual (Page 28)

25
Error messages
NOTE
• An error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc. If this happens, check the relevant items, be sure to take the necessary
measures, then perform Audyssey® Auto Setup over again.
• If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker
connections and repeat the measurement process from the beginning.
• Be sure to turn off the power before checking speaker connections.
Examples Error details Measures
AUDYSSEY AUTO SETUP
RETURN
Retry
No microphone or speaker
Cancel
Caution!
• The connected setup microphone is broken, or a device other than the
supplied setup microphone is connected.
• Not all speakers could be detected.
• The front L speaker was not properly detected.
• Connect the included setup microphone to the SETUP MIC jack of this unit.
• Check the speaker connections.
AUDYSSEY AUTO SETUP
RETURN
Retry
Ambient noise is too high
or level is too low
Cancel
Caution!
• There is too much noise in the room for accurate measurements to be
made.
• Speaker or subwoofer sound is too low for accurate measurements to be
made.
• Either turn off any device generating noise or move it away.
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction in which the speakers are
facing.
• Adjust the subwoofer’s volume.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
RETURN
Retry
Front R None
Cancel
Caution!
• The displayed speaker could not be detected.
(The screen on the left indicates that the front right speaker cannot be
detected.)
• Check the connections of the displayed speaker.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
RETURN
Retry
Skip
Front R Phase
Cancel
Caution!
• The displayed speaker is connected with the polarity reversed.
(The screen on the left indicates that the polarity phases of the front right
speakers are reversed.)
• Check the polarity of the displayed speaker.
• For some speakers, this error message may be
displayed even if the speaker is properly connected.
If you are sure the connection is correct, press
ui
to select “Skip”, then press ENTER .
Set up speakers (Audyssey® Auto Setup)
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
Basic v
ersion