Marantz SR6006 - Manual (Page 106)

103
AUDIO/VIDEO ADJUST
n A-DSX Soundstage
Default settings are underlined.
Adjust Audyssey DSX™ setting and sound stage parameters.
Setting items Setting details
Audyssey DSX™
Provides more immersive
surround sound by adding
the new channels. ON–Height– : Turn on A-DSX processing for height expansion.
ON–Wide– : Turn on A-DSX processing for wide expansion.
OFF : Do not set Audyssey DSX™.
Stage Height
Adjust sound stage height
when using front height
speakers. –10 – +10 (0)
• “Audyssey DSX™” can be set when you are using front height speakers
or front wide speakers.
• “Audyssey DSX™” is only valid when using a center speaker.
• “Audyssey DSX™” is valid when surround mode is AUTO mode other
than PL gz Height.
• “A-DSX Soundstage” cannot be configured if the HD Audio source being
played includes Front height and Front wide channels. In this case, the
respective channels are played back using the input signals.
About Audyssey Dynamic Surround Expansion (A-DSX)
Audyssey DSX™ is a scalable surround expansion system that adds
new channels to improve the surround impression. Based on research
in human hearing Audyssey DSX™ adds a pair of Wide channels in the
front because that information is critical in the rendering of a realistic
soundstage.
Audyssey DSX™ then adds a pair of Height channels above the main
front channels to reproduce the next most important acoustical and
perceptual cues related to soundstage depth. In addition to creating
these new channels, Audyssey DSX™ applies Surround Envelopment
Processing to enhance the blend between the front and side/back
surround channels. The result is a much more seamless and enveloping
home theater experience.
Stage Width
Adjust sound stage width
when using front wide
speakers. –10 – +10 (0)
Manual EQ
Default settings are underlined.
Use the graphic equalizer to adjust the tone of each speaker.
“Manual EQ” can be set when “MultEQ® XT” setting (
vpage 101 ) is “Manual”.
Setting items Setting details
Curve Copy
Copy “Audyssey Flat” curve
from MultEQ® XT. Yes : Copy.
No : Do not copy.
• “Curve Copy” is displayed after Audyssey® Auto Setup has been
performed.
• When you select “Curve Copy” and press ENTER , the “Set EQ curve to
Audyssey Flat?” prompt is displayed. Select either “Yes” or “No”, and
press
ENTER .
Default
The “Manual EQ” settings
are returned to the default
settings. Yes : Reset to the defaults.
No : Do not reset to the defaults.
When you select “Default” and press ENTER ,
the “Return all settings to the default?”
prompt is displayed. Select either “Yes” or
“No”, and press
ENTER .
Adjust Channel
Correct the tone of each
speaker. q Select the speaker tone adjustment method.
All : Adjust the tone of all speakers together.
L/R : Adjust the tone of left and right speakers together.
Each : Adjust the tone of each speaker.
w Select the speaker.
e Select the adjustment frequency band.
63Hz / 125Hz / 250Hz / 500Hz / 1kHz / 2kHz / 4kHz / 8kHz / 16kHz
• Select the speakers you want to adjust when “L/R” or “Each” is
selected.
r Adjust the level.
–20.0dB – +6.0dB (0.0dB)
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
BD