Marantz SR6006 - Manual (Page 76)

73
n HDMI control function ( vpage 73 )
n Sleep timer function ( vpage 74 )
n Adjusting the volume of the speakers
( vpage 75 )
n AirPlay ( vpage 76 )
n Party mode function ( vpage 77 )
n Zone Management function ( vpage 78 )
n Operating a media controller to play music and still
pictures ( vpage 79 )
n Web control function ( vpage 80 )
n Dual backup memory function ( vpage 82 )
n Panel lock function ( vpage 82 )
n Various memory functions ( vpage 83 )
Playback (Basic operation) ( vpage 27 )
Settings ( vpage 20 )
Selecting a listening mode (SURROUND MODE)
( vpage 55 )
Playback (Advanced operation)
Convenient functions
HDMI control function
If you connect the unit and an HDMI control function compatible TV or
player with an HDMI cable and then enable the HDMI control function
setting on each device, the devices will be able to control each other.
n Operations possible by HDMI control
• This unit power off can be linked to the TV power off step.
• You can switch audio output devices with a TV operation.
When you set “Output audio from amp” in the TV audio output
setup operation, you can switch the amp power on.
• You can adjust this unit volume in the TV volume adjustment
operation.
• You can switch this unit input sources through linkage to TV
input switching.
• When playing the player, this unit input source switches to the
source for that player.
• If you switch the input source of the unit to “TV”, you can
play TV audio with this unit ( vpage 7 “About ARC (Audio
Return Channel) function”).
• When “HDMI Control” – “Control” ( vpage 110 ) in the menu
is set to “ON”, signals input to the HDMI input connector are
output to the television or other device connected to the HDMI
output connector, even if the power of this unit is in standby
(pass-through function).
• To play the audio of a TV that does not support the ARC function
with the unit, connect the TV with an optical digital connection.
• To use the pass-through function, connect an HDMI connection
device that is compatible with HDMI control.
n Setting procedure
1 Set the HDMI output connector corresponding with
the HDMI control function.
Set “HDMI Control” – “Control” ( vpage 110 ) to “ON“.
2 Turn the power on for all the devices connected by
HDMI cable.
3 Set the HDMI control function for all devices
connected by HDMI cable.
• Please consult the operating instructions for the connected devices
to check the settings.
• Carry out steps 2 and 3 should any of the devices be unplugged.
4 Switch the television input to the HDMI input
connected to this unit.
5 Switch this unit input to the HDMI input source and
check if the picture from the player is ok.
6 When you turn the TV’s power to standby, check
that the power of this unit also goes to standby.
If the HDMI control function does not operate properly, check the
following points.
• Is the TV or player compatible with the HDMI control function?
• Is “HDMI Control” – “Control” (
vpage 110 ) set to “ON”?
• Is “Power Off Control” ( vpage 110 ) set to “All” or “Video”?
• Is “Control Monitor” ( vpage 110 ) set for the monitor output
connected to television?
• In the case of dual monitor connection, is “Control Monitor”
( vpage 110 ) on the menu set to a monitor without HDMI control?
• Are the HDMI control function settings of all devices correct?
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
vSee overleaf
BD