Marantz SR6006 - Manual (Page 72)

69
1
Set up the
remote control unit
n Set up the operation mode
Press AMP to set the remote control unit to AMP-
operation mode.
Press AMP
2 Connect the setup microphone.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the
recommendations in the manual.
Set the following items
If necessary.
Start Auto Setup
Enter Cancel
When the setup microphone is
connected, the following screen is
displayed.
Set up speakers
around items indicate the settings.
This section provides the setup methods of speaker systems other than the 7.1-channel system with surround back speakers.
For the setup methods of the 7.1-channel system with surround back speakers, see
C page 4 “SETUP WIZARD” .
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment ( vpage 69 “Set up “Amp Assign””).
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers ( vpage 70
“Set up “Channel Select””).
3
Set up “Amp Assign”
Use ui to select “Amp Assign”, and then press
ENTER .
AMP ASSIGN [1/2]
RETURN
Assign Mode NORMAL
5.1 ch/7.1 ch
Return
ZONE2: ZONE3:
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the
recommendations in the manual,
Set the following items
If necessary.
Change assigned power amp to match the speaker system
Enter Cancel
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
vSee overleaf