Marantz SR6006 - Manual (Page 73)

70
Set up speakers
6
Set up “Channel Select”
Use ui to select “Channel Select”, and then press
ENTER .
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the
recommendations in the manual,
Set the following items
If necessary.
Enable skip of measuring unused channels to reduce time
Enter Cancel
Subwoofer
Surround Back
Measure
Measure (2 spkrs)
RETURN Enter Cancel
Measure subwoofer channel
Channel Select
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the
recommendations in the manual,
Set the following items
If necessary.
Enable skip of measuring unused channels to reduce time
Enter Cancel
7
Use ui to select a channel.
Subwoofer Select for no subwoofers to be used. In this case, go
to step 8.
Surround
Back
Select the number of surround back speakers to be
used. In this case, go to step 9.
• “Surround Back” can be set when “Amp Assign” is
set to “NORMAL”.
8
Use o p to set whether or not a subwoofer channel
is measured.
Measure Set for measuring a subwoofer.
Skip Set for no measuring of a subwoofer.
9
Use o p to set whether or not a surround back
channel is measured.
Measure
(2 spkrs) Set for measuring two surround back speakers.
Measure
(1 spkr) Set for measuring a surround back speaker.
Skip Set for no measuring of a surround back speaker.
10
Press RETURN .
Proceed to page 22 STEP1 Preparation step 6.
NOTE
After performing Audyssey® Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey® Auto Setup again.
4
Use o p to select the
configuration of the connected
speakers.
NORMAL Select the “NORMAL” setting to perform 7.1-channel
playback using the surround back, front height, or
front wide speakers.
ZONE2 Select the “ZONE2” setting to assign the unit’s built-
in power amplifier for ZONE2 and output the audio
in stereo.
ZONE3 Select the “ZONE3” setting to assign the unit’s built-
in power amplifier for ZONE3 and output the audio
in stereo.
SPKR-C Select the “SPKR-C” setting to connect the front
speakers via the bi-amp connection.
F.Height Select the “F.Height” setting to use the front height
speaker for playback.
F.Wide Select the “F.Wide” setting to use the front wide
speaker for playback.
5
Press RETURN to exit the “Amp Assign” setting.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion