NavCom SF-2050 Rev.G - Manual (Page 84)

SF-2050 User Guide – Rev. G
In StarUtil, enable the Event Latch message (0xB4) in
the NCT Binary Messages output list. Select
Receiver > Messages > NCT output from the menu
bar to open the list. Set the Message Rate for 0xB4 to
On Trigger. Right-Click in the Rate cell for message
B4. Select Other > On Trigger from the menu (see
Figure D3). Once configured, the Event Latch
Message (0xB4) is output upon recognition of an
input trigger by the receiver.
The PPS and Event Latch window opens (see Figure
D2).
Figure D3: Event Latch Output Rate Configuration
‡
Message 0xB4 is described in the
Technical Reference Manual (see Related
Documents in the fore-matter).
Figure D2: PPS & Event Latch Configuration
D-82