Orion System RNE Modular Controller - Manual (Page 9)

RNE Modular Controller Field Technical Guide
OVERVIEW
9
Parts and Descriptions
PART NO. PART DESCRIPTION ILLUSTRATION PAGE NO.
OE230
OE231
Duct Temperature Sensor - 6” Probe
Duct Temperature Sensor - 12" Probe
OE230 = 6″ probe length. OE231 = 12″ probe length. Used for return or
supply air temperature sensing applications. Includes: 10k Ohm Duct
Temperature Sensor, 2 wire only. Page 22
OE250 Outdoor Air Temperature Sensor
Used for temperature sensing applications. Includes: 10k Ohm Outside
Air Temperature Sensor, 2 wire, mounted in a weatherproof handy box
only.
Page 23
OE258-01 Building Static Pressure Sensor
Used for Building Pressure Sensing. Includes: -0.25 to +0.25″ W.C., 0-5
VDC, 24 VAC/VDC supply power Building Pressure Sensor only.
Page 33
OE265-11 Room Mounted RH Sensor - 3% - 0-5 VDC Output
Includes: 0-5 VDC, Room Mounted Relative Humidity Transmitter only.
Used for room air humidity sensing applications.
Page 31
OE265-13 Outdoor Air Temperature & Humidity Sensor
Includes: 0-5 VDC, Outside Air Relative Humidity Transmitter mounted
in a weatherproof, round handy box only. Used for outside air humidity
sensing applications.
Page 30
OE265-14 Return Air RH Sensor - 3% - 0-5 VDC Output
Includes: 0-5 VDC, Return Air Relative Humidity Transmitter mounted in a
weatherproof, round handy box only. Used for return air humidity sensing
applications.
Page 32
OE271 Duct Static Pressure Sensor
Used for duct static pressure sensing applications. Includes: 0-5″ W.C.,
0-5 VDC, Static Pressure Sensor only.
Page 18
OE275-01 Suction Pressure Transducer
Includes: Suction Line Pressure Transducer with modular cable. The cable
is supplied with a modular connector on one end and bare stripped wires
on the other end. The OE275-01 Suction Pressure Transducer is used to
monitor refrigerant suction line pressure of a DX cooling coil when a digital
compressor is used. The Suction Pressure Transducer is provided with a
¼″ SAE Flare connection for connection to the refrigerant suction line.
Pages
40,41
43,44
OE281-04 Bypass Damper Actuator
Includes: OE281-04 Modulating Damper Actuator. Used when a terminal
unit is to be used as a bypass damper for fi eld or factory controls mounted
by others. Accepts a 0-10 VDC signal.
Page 37