Teac MX-View Version 1.0b1 - Manual (Page 67)

67
These edit commands include Cut, Copy, and Clear. You may switch to a different
clipboard number and perform another Cut, Copy, or Clear command.
Placing Contents from the Clipboard:
First select the desired clipboard. Choose any type of Paste or Insert edit command to
place contents from the clipboard onto the main MX-View window. You may switch to a
different clipboard number and perform another Paste or Insert command.
All clipboard entries retain their information from project to project. They are, however,
cleared when the MX-2424 is turned off or when an Unmount or disk cleanup command
is issued.

Note: If a clipboard is not selected, contents will be placed to clipboard 1, the default clipboard.
7-10 Event Slip
An Event Slip edit slides audio to the left or right without moving the In or Out points.
An Event Slip can be performed by selecting an event, holding down A, and Clicking and
Dragging the selected event. Note that you must use the Drag and Trim Tool for this
feature.
Before:
After:
Event Slip retains the In and Out points and grabs more audio on the left or right side.
Audio outside the In and Out point remains unaffected.
Event is selected for
Event Slip
Event is Slipped to the
right by holding down
the A key, selecting the
event, and dragging to
the right.
Note that the In and Out
points remain unaltered