Verilink QPRI 2921 (880-503143-001) Product Manual - Manual (Page 19)

Quick Set-Up
Verilink QPRI 2921 2-3
Getting Started
After the NCM and QPRI modules and their NIM/CIM have been
installed in their appropriate shelf/slots (self-test has been
successfully completed), connect the Craft Interface Cable
(P/N 458-501788-008) to the Local port on the NCM front panel to
access the ASCII interface.
Terminal
Parameters
Terminal parameters: 19.2 kbit/s baud rate, 8 data bits, no parity,
one stop-bit, and no flow-control. Make sure that the X-On/X-Off
flow control is disabled.
Logging On 1. Press E NTER to display the pSH+> prompt and type craft.
2. Press E NTER to display the NCM Main Menu.
If the NCM Main Menu display Figure 2-2 shows the QPRI in the
proper shelf/slot position, you may continue with the
configuration tasks.
The default password for the NCM will give the user Access Level 2
permissions. If you need a higher access level, see your NCM 2000
User Manual for more information.
Bus
Compatibility
If there is no indication of the QPRI on the “shelf map” on the NCM
Main Menu, the modules may be assigned to different busses on
the shelf backplane.
NCMs are usually sent out with their default bus being the C bus.
Other modules usually are sent out with their default bus being the
A bus.
Assign the QPRI to the bus on which the NCM resides by accessing
the QPRI’s ASCII port directly.
1. Connect the Craft Interface Cable directly to the LOCAL port
on the QPRI module.
2. Press E NTER .
3. From the QPRI Main Menu, select the following:
O) node administration>B) change the ACP bus
4. Once the bus assignment has been made, reboot the
reassigned module by either
• Using the reset reset reset reset command from the Controller Administration
Menu, option R, or
• Reseating the module in its slot.