Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 117)

V T 1 0 0 I n t e r f a c e 4-39
Figure 4.29 Diagnostics Screen
Description Describes the type of interface selected for testing.
Loop Type Describes the type of loop test (if any) performed on the selected interface.
Setting Displays the bandwidth on which you wish to perform the BERT.
Pattern Specifies the pattern to be transmitted during a BERT for the selected port.
Length Displays the length of time for which the BERT should run for the selected
interface.
State Displays the current BERT state for the selected interface.
Test Details Screen
The Test Details screen lets you set some test parameters and view other read-
only parameters. This screen is also used to initiate a BERT or Loop Test.
The Network Interface Test Details screen, shown in Figure 4.30, and the
Serial Interface Test Details screen contain the same BERT Table parameters,
which are described below. However, their Loop Tables at the bottom of the
screen contain different options that are also described below.