Utilities, Software upgrade, Utilities -45 – Verilink WANsuite 5330 (34-00302.F) Product Manual User Manual
Page 73: Software upgrade -45
W e b S e r v e r I n t e r f a c e
3-45
Requested Report Size
Establishes how many IP addresses will be reported as the “Top Talkers.”
NOTICE:
While you may request any number, the unit is internally limited to a
maximum report size of 20.
Report #
A unique number that identifies the generated report. This number is
generated automatically and is incremented sequentially for each report. This
number can also be used by management stations for automatic polling (via
the ipadv2.mib).
Size
Displays the actual number of IP addresses identified as Top Talkers in the
generated report. The maximum report size is 20.
Start Time
Displays the time at which the Top Talkers report was initiated (based on
System Up Time).
System Up Time
Displays the amount of time the unit has been operational since it was turned
on or last reset.
The Top Talkers table reports in descending order the IP addresses that have
generated the most traffic during the requested report’s duration. For each IP
address listed, the report displays the number of Rx frames, Rx octets, Tx
frames, and Tx octets that have been passed across it. In addition, the
Timestamp field indicates the time at which a packet was examined for the
specified IP address.
Utilities
The options available beneath the Utilities branch of the navigation tree serve
as utilities for upgrading the software in your WANsuite 5330, managing
access with passwords, and logging off the system.
Software Upgrade
Use this screen (Figure 3.34) to upgrade the software in your WANsuite 5330
unit. The revision level for the software your unit is currently using will be
displayed in the top frame of the Web server interface. After installing a
software upgrade, the new revision level will be displayed in this frame.
NOTICE:
During the last 2 minutes of the upgrade process, the unit’s memory will
be reprogrammed; the unit will be inoperable during this time.
CAUTION:
Do not allow power to be removed from the unit while its memory is
being reprogrammed.