Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 89)

V T 1 0 0 I n t e r f a c e 4-11
RTS/CTS Delay The Request To Send/Clear To Send parameter determines how long the unit
waits before it changes the level of CTS to match RTS when the CTS
parameter is set to “Internal.”
Values: Normal (~30 ms delay), Long (~100 ms delay)
Default: Normal
DTR Alarm Control Lets you set DTR Alarm Control parameters.
Values: Enable, Disable
Default: Disable
DTR Alarm Status Lets you view the current DTR Alarm status.
Format Selects the port’s operating mode.
Values: Sync, Async
Default: Sync
Flow Control Selects the type of flow control to be used if the port is asynchronous.
Values: None, Xon/Xoff, RTS/CTS
Default: None
Character Size Selects the number of bits to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Parity Selects the setting for the parity bit if the port is asynchronous.
Values: None, Odd, Even
Default: None
Stop Bit Selects the number of bits to end the character.
Values: 1, 2
Default: 1
Current Pin Status
The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Serial screen.
Ethernet (IP Details) Screen
The 10/100 Ethernet (IP Service Details) screen (Figure 4.9) lets you
configure the IP parameters listed below.