Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 68)

3-40 W A N s u i t e 5 3 3 0
Figure 3.29 SNMP Details Screen
Read Community Accepts a character string identifying the group authorized to perform read
operations. The default setting is “Public.”
Write Community Accepts a character string identifying the group authorized to perform write
operations. The default setting is “Private.”
Trap Community Accepts a character string that is included in SNMP traps generated by the
unit. The default setting is “Public.”
Trap IP Address Accepts the IP address of a network device where alarm reporting traps are to
be sent.
The unit detects and reports DDS network alarms and provides several
options for reporting them, one of which is SNMP traps. When a network
alarm occurs, the unit sends a trap message to as many as eight destinations
on your network. The unit will report each alarm by transmitting an SNMP
“trap” to each non-zero Trap IP address.
Diagnostics Screen
This screen shows an upper-level view of all the interfaces so you can see if
any port is under test, and if so, view the results. Diagnostic parameters may
be changed on the Test Details screen (Figure 3.31). The parameters on the
Diagnostics screen are described in the paragraphs below.