AEC HE Mass Flow Series Drying hoppers - Manual (Page 43)

Page 42 HE
• CHE • BCHE Mass Flow Series Drying Hoppers
Figure 15
Display Readout for Mode Settings
PV
SV
SV
SV
SV
SV
SV
SV
Menu display
Level 0 mode
Level 1 mode
Level 2 mode
Setup mode
Expansion mode
Option mode
Calibration mode
Setting 1/16 DIN E5CK Security in Protect Mode
1. To access protect mode, press and hold the
A
M
A/M key and the display key for
more than one and a half to two (1.5 to 2) seconds.
2. The display should read SECr for security mode. If you press the display key for
short presses you will toggle between ( SECr ) and ( KEYP ) for AM protect.
3. With the display reading SECr , set the security levels by the arrow up and down keys.
Change the security level to 1 to make changes to the operating parameters. Nomad carts
are factory set to Security Level 5.
Available Security Levels
Security level
Mode 0 1 2 3 4 5 6
Calibration X
Option
X X
Expansion X X
Setup X X
Level 2 X X X
Level 1 X X X X
Level 0 X X X X X X
To return to the main display (run mode), press and
hold the A/M and Display key for 1.5 to 2 seconds.