Grass Valley 8900NET v.4.4.0 - Manual (Page 62)

62 8900NET (Net Card) — Instruction Manual
Using the 8900NET GUI
8900NET Network Web Page
Use
this
link
To view or change the module identity and currently assigned network
addresses for the 8900NET module access the Network web page illus-
trated in
Figure 35 .
Note Depending on the type of frame this module is installed in, this network con-
figuration is saved on either the 8900NET module or on the frame backplane.
Refer to
Network Configuration Storage on page 25 for details.
Figure 35. 8900NET Module Network Identification Page
After initial frame network addressing is done using the RS-232 port, sub-
sequent address changes may be made using the web page shown above.
Note SubNet Mask and Gateway IP Address are required.
Rebooting the NET Module
Reboot the module for changes to take effect. You can reboot the 8900NET
module from the Network page by clicking the
reboot button. A reboot
button can also be found on the Configuration page.