Yaskawa MP940 Hardware Manual - Manual (Page 11)

MotionSuite™ MP940 Machine Controller Hardware Manual Section 2: Startup
8
3. Insert the mounting clips into the mounting holes in the MP940, as shown in
the figure below.
4. While pulling out on the mounting clip, hook the mounting clip on the top of
the MP940 case.
5. Mount the lower clip in the same manner.
Mounting the Battery Holder
Follow the steps below to mount the battery holder. The mounting method for the
MP940 battery holder is shown in the following figure.
1. Insert the battery holder into the MP940 upper battery holder mounting hole.
2. With the upper lock in contact with the battery holder mounting hole (top),
push the bottom of the battery holder into the bottom mounting hole.
Clip
MP940
Servo Amplifier
Clip Mounting
Hook
3.
4.
Mounting Hole
Figure 2.3: Inserting the Mounting Clips