Yaskawa V1000-Series Option SI-EP3/V PROFINET - Manual (Page 15)

4 Option Components
YASKAWA TOEP YEACOM 06A V1000 Option PROFINET SI-EP3/V Installation Manual 15
Table 3 Option LED States
Name
Indication
Operating Status Remarks
Color Status
MS
(visible
through
drive cover)
– OFF Power supply OFF
Power is not being supplied to the
drive.
Green ON Option operating
The option is operating normally and
initialization is complete.
Green Flashing (1) Diagnostics Diagnostic data available.
Green Flashing (2) Configuration tool Identified by a configuration tool.
Red ON
Default MAC or fatal error
occurred.
Default MAC address has been
programmed or the option has
detected an unrecoverable error.
Red Flashing (1) Configuration error (non-fatal) Configuration error.
Red Flashing (2) No IP (non-fatal) No IP address assigned.
Red Flashing (3) No station name (non-fatal) No station name assigned.
Red Flashing (4) Init failure (non-fatal) Failed to initialize module.
Green/
Red
Flashing Option self-test The option is in self-test mode.
NS
(visible
through
drive cover)
– OFF Offline or Power supply OFF –
Green ON Connected
Connection established with I/O
controller and in RUN mode.
Green Flashing Connected and stopped
Connection established with I/O
controller and in STOP mode.
Red ON BUS fault Unrecoverable BUS fault.
Red Flashing (1) Lost communication
Host communication is temporarily
lost.
Red Flashing (2) Lost link No link detected to network.
10/100
(visible at
RJ45 cable
ports) Yellow OFF 10 Mbps is established –
Yellow ON 100 Mbps is established –
LINK/ACT
(visible at
RJ45 cable
ports)
Green OFF Link is not established –
Green ON Link is established –
Green Flashing
Link is established and there is
network activity
–