Yaskawa V1000-Series Option SI-EP3/V PROFINET - Manual (Page 63)

11 Troubleshooting
YASKAWA TOEP YEACOM 06A V1000 Option PROFINET SI-EP3/V Installation Manual 63
Related Parameters
Table 15 Parameters related to bUS Error Auto-Reset Functionality
■ Option Fault Monitors U6-98 and U6-99
The option can declare error/warning conditions via drive monitor parameters on the drive
digital operator as shown in Table 16 .
Table 16 Option Fault Monitor Descriptions
No.
(Addr. Hex)
<2> If F6-01 is set to 3, then the drive will continue to operate when a bUS error is detected. Use caution and proper
safety measures, when installing an emergency stop switch.
<5> Available in drive software versions PRG:1024 and later when combined with option firmware version
VST800251 and later. Not available in drive software versions PRG:508.
Name Description Default
F6-01
(03A2)
Operation Selection after
Communications Error
Determines drive response when a bUS error is
detected during communications with the option.
0: Ramp to Stop
1: Coast to Stop
2: Fast-Stop
3: Alarm Only
<2>
4: Alarm (d1-04) <5>
5: Alarm Ramp to Stop <5>
<6> Available in option firmware version VST800251 and later.
1
F6-14 <6>
(03BB)
bUS Error Auto Reset
0: Disabled
1: Enabled
0
F7-16 <6>
(03F4)
Communication Loss Timeout
Sets the timeout value for communication loss
detection in tenths of a second.
A value of 0 disables the connection timeout.
Example: An entered value of 100 represents 10.0
seconds.
Note: A change to this parameter setting is not
effective until main power to the drive is cycled.
0.0
Fault Condition Fault Declared
Status Value
(U6-98/U6-99)
Description
No Fault n/a 0 No faults.
Force Fault EF0 3
Network sent a message to force this node to the fault
state.
Network Link
Down
BUS ERROR 1300 No network link to option board.
Network Failure BUS ERROR 1301 Connection with PLC Timeout.
Default MAC
Address
None 1303
Factory default MAC Address programmed into the
option. Return for reprogramming.
No IP Address None 1304 No IP Address has been programmed into the option.
No Station Name None 1305 No Station Name has been programmed into the option.