Yaskawa GPD 515-G5 Modbus RTU - Manual (Page 54)

7-18 Registers
Drive Parameter Registers (Read/Write) (continued)
REGISTER PARAMETER PARAMETER PARAMETER LIMITS / DESCRIPTION INITIAL
(in hex) FUNCTION SETTING VALUE
313h E2-06 Motor Leakage Inductance 0.0 to 30.0% (2)
314h E2-07 Motor Iron-core Saturation Coefficient 1 0.00 to 0.50 0.50
315h E2-08 Motor Iron-core Saturation Coefficient 2 0.00 to 0.75 0.75
316h E2-09 Motor Mechanical Loss 0.0 to 10.0% 0.0
317h E3-01 Motor 2 Control Method Selection 0 V/f Control
1 V/f with PG Feedback 2
2 Open Loop Vector
3 Flux Vector
318h E4-01 Motor 2 Max. Output Frequency 50.0 to 400.0 Hz 7
319h E4-02 Motor 2 Maximum Voltage 0.0 to 255.0V (230V unit)
0.0 to 510.0V (460V unint)
230.0
460.0
31Ah E4-03 Motor 2 Max. Voltage Frequency 0.0 to 400.0 Hz 60.0
31Bh E4-04 Motor 2 Mid. Output Frequency 0.0 to 400.0 Hz (1)
31Ch E4-05 Motor 2 Mid. Output Freq. Voltage 0.0 to 255.0V (230V unit)
0.0 to 510.0V (460V unint)
(1)
31Dh E4-06 Motor 2 Min. Output Frequency 0.0 to 400.0 Hz (1)
31Eh E4-07 Motor 2 Min. Output Freq. Voltage 0.0 to 255.0V (230V unit)
0.0 to 510.0V (460V unint)
(1)
31Fh E5-01 Motor 2 Rated Current 0.00 to 99.99 or 100.0 to 1500.0 Amps (2)
320h E5-02 Motor 2 Rated Slip 0.00 to 20.00 Hz (2)
321h E5-03 Motor 2 No-Load Current 0.00 to 99.99 or 100.0 to 1500.0 Amps (2)
322h E5-04 Motor 2 Number of Poles 2 to 48 poles 4
323h E5-05 Motor w Line-to-Line Resistance 0.000 to 65.000 Ohms (2)
324h E5-06 Motor 2 Leakage Inductance 0.0 to 30.0% (2)
Notes (for this page only):
1. Initial value differs depending on the Control Method (A1-02).
2. Initial value differs depending on drive capacity (o2-04).