Yaskawa GPD 515-G5 Modbus RTU - Manual (Page 60)

7-24 Registers
Drive Parameter Registers (Read/Write) (continued)
REGISTER PARAMETER PARAMETER PARAMETER LIMITS / DESCRIPTION INITIAL
(in hex) FUNCTION SETTING VALUE
48Dh L3-06 Stall Prevention Level during Running 30 to 200% 160
48E-48Fh Reserved
490h L4-01 Speed Coincidence Frequency 0.0 to 400.0 Hz 0.0
491h L4-02 Speed Coincidence Width 0.0 to 20.0 Hz 2.0
492h L4-03 Speed Coincidence Frequency (+/-) -400.0 to +400.0 Hz 0.0
493h L4-04 Speed Coincidence Width (+/-) 0.0 to 20.0 Hz 2.0
494h L4-05 Frequency Reference Loss 0 Stop 0
Detection 1 Run at 80% of Frequency Reference
495h L5-01 Number of Auto Restart Attempts 0 to 10 0
496h L5-02 Auto Restart Operation Selection 0 No Fault Relay 0
1 Fault Relay Active
497h L5-03 Fault Restart Time 0.5 to 180.0 seconds 10.0
498h L6-01 Torque Detection Selection 1 0 Disabled
1 Detected during Speed Agree
(operation continues)
2 Detected during Running (operation
continues)
0
3 Detected during Speed Agree (drive
faults)
4 Detected during Running (drive faults)
499h L6-02 Torque Detection Level 1 0 to 300% 150
49Ah L6-03 Torque Detection Time 1 0.0 to 10.0 seconds 0.1
49Bh L6-04 Torque Detection Selection 2 0 Disabled
1 Detected during Speed Agree
(operation continues)
2 Detected during Running (operation
continues)
0
3 Detected during Speed Agree (drive
faults)
4 Detected during Running (drive faults)