Yaskawa GPD 515-G5 Modbus RTU - Manual (Page 58)

7-22 Registers
Drive Parameter Registers (Read/Write) (continued)
REGISTER PARAMETER PARAMETER PARAMETER LIMITS / DESCRIPTION INITIAL
(in hex) FUNCTION SETTING VALUE
415h H4-01 Multi-function Analog Monitor 1
Selection (terminal 21)
1 to 31h 2
416h H4-02 Multi-function Analog Monitor 1 Gain 0.00 to 2.50 1.00
417h H4-03 Multi-function Analog Monitor 1 Bias -10.0 to +10.0% 0.0
418h H4-04 Multi-function Analog Monitor 2
Selection (terminal 23)
1 to 31h 3
419h H4-05 Multi-function Analog Monitor 2 Gain 0.00 to 2.50 0.50
41Ah H4-06 Multi-function Analog Monitor 2 Bias -10.0 to +10.0% 0.0
41Bh H4-07 Multi-function Analog Monitor Signal 0 0 to 10 V DC 0
Level Selection (terminal 21 & 23) 1 -10 to +10 V DC
41Ch H5-01 Serial Communication Address 0 to 1Fh 1Fh
41Dh H5-02 Serial Communication Baud Rate 0 1200 bps
1 2400 bps 3
2 4800 bps
3 9600 bps
41Eh H5-03 Serial Communication 0 No Parity
Parity Selection 1 Even Parity 0
2 Odd Parity
41Fh H5-04 Stopping Method after Serial 0 Ramp to Stop
Communication Error 1 Coast to Stop 3
2 Fast-Stop
3 Alarm Only
420h H5-05 Communication Error (CE) Detection 0 Disabled 1
Selection 1 Enabled