Yaskawa GPD 515-G5 Modbus RTU - Manual (Page 62)

7-26 Registers
Drive Parameter Registers (Read/Write) (continued)
REGISTER PARAMETER PARAMETER PARAMETER LIMITS / DESCRIPTION INITIAL
(in hex) FUNCTION SETTING VALUE
500h o1-01 Monitor Selection 4 to 28, 32, 33 (2) 6
501h o1-02 Monitor Selection after Power-up 1 Frequency Reference
2 Output Frequency 1
3 Output Current
4 Selected Monitor
502h o1-03 Digital Operator Display Selection 0 to 39999 0
503h o1-04 Digital Operator Display Units 0 Hz 0
1 RPM
504h o1-05 Parameter / Address Display 0 Parameter Number 0
Selection 1 Modbus Address
505h o2-01 LOCAL / REMOTE Key 0 Disabled 1
Selection 1 Enabled
506h o2-02 STOP Key Function during 0 Disabled 1
Remote Run 1 Enabled
507h o2-03 User Parameter Default Value 0 Disabled
1 Set Default 0
2 Clear all
508h o2-04 kVA Selection (Drive Model No.) 0 to FFh (1)
509h o2-05 Digital Operator 0 Drive accepts freq. after ENTER key 0
ìMotor Operated Potî 1 Drive accepts freq. immediately
Notes (for this page only):
1. Not initialized. Initial value differs depending on the drive capacity.
2. Range shown is for flash software version‘1030’ and CPU version ‘30’. Range differs for previous versions.