Yaskawa Sigma-5 Large Capacity Users Manual: Design and Maintenance-Rotary Motors-Mechatrolink-III Communication Reference - Manual (Page 217)

5.6 Anti-Resonance Control Adjustment Function (Fn204)
5-51
5
Adjustm
e
nts
5.6.3 Related Parameters
The following table lists parameters related to this function and their possibility of being changed while exe-
cuting this function or of being changed automatically after executing this function.
• Parameters related to this function
These are parameters that are used or referenced when executing this function.
• Allowed changes during execution of this function
Yes : Parameters can be changed using SigmaWin+ while this function is being executed.
No : Parameters cannot be changed using SigmaWin+ while this function is being executed.
• Automatic changes after execution of this function
Yes : Parameter set values are automatically set or adjusted after execution of this function.
No : Parameter set values are not automatically set or adjusted after execution of this function.
Parameter Name
Mid-execution
changes
Automatic
changes
Pn160 Anti-Resonance Control Related Switch Yes Yes
Pn161 Anti-Resonance Frequency No Yes
Pn162 Anti-Resonance Gain Compensation Yes No
Pn163 Anti-Resonance Damping Gain No Yes
Pn164 Anti-Resonance Filter Time Constant 1 Compensation Yes No
Pn165 Anti-Resonance Filter Time Constant 2 Compensation Yes No