Sealey VS8622 - Manual (Page 22)

2) Wait a few minutes while the device is activating the brakes.
When they are activated successfully, following screen shows:
If the tool fails to close the brakes, an “Activation Failed!
Press any key to con.” message shows.
3) Press any key to return to previous menu.
E. Change Brake Fluid
WARNING: DO NOT operate the brake pedal until you are
prompted to!
Make sure the central lock is deactivated!
Use extreme caution during the whole bleeding process as the
pressure of pump bleed screw will be up to 100 bar!
1) Connect a charger to vehicle battery.
2) Prepare at least 2.0 litres of brake fluid and pour the liquid into
brake fluid accumulator.
3) Connect the fluid accumulator to brake’s master cylinder with the
accumulator tube.
4) Plug the device to vehicle DLC and turn ignition on.
5) Use UP/DOWN button to select SBC-Mercedes from
Diagnostic Menu and press Y button to confirm.
…………… Activate
Brake …….. .
Activation Done!
…… Diagnostic Menu …………… …
1/3
1) EPB-Audi A8
2) EPB-Other VAG
►3) SBC-Mercedes
VS8622_1.03_12/03/09
21