Precision Digital PD941 - Manual (Page 42)

ConsoliDator Multi-Channel Controller Instruction Manual
42
Multiple Channel Operation
Screen
To the right is an example of a
multiple channel operation screen
for a four input application. The
screen reflects all of the inputs that
were detected or enabled during
setup. Depending on the actual
number of inputs in use, this screen
will adjust its size and proportions
automatically.
Note: It is recommended not to exceed 8
channels or graphics may overlap.
SETUP AUTO ACK NEXT
Ch1 Ch2 Ch3 Ch4
Ch 1:
Ch 2:
Ch 3:
Ch 4:
13.000
14.000
15.000
mA
mA
mA
mA
mA
12.000
SETUP Press to enter setup menu (Password restricted).
AUTO / MANUAL The AUTO key indicates the unit is in Automatic mode. Press it to
switch to Manual mode. Press NEXT to return to main screen. Once
in Manual mode press MANUAL to switch to Automatic mode.
Note: The AUTO / MANUAL modes are password restricted.
ACK Press to acknowledge (reset) the relays assigned to Supervisory,
Summary or Annunciator Alarm functions and to silence the buzzer.
NEXT Press to scroll to the next operation screen.
Single Analog Input
Operation Screen
For each analog input channel,
there is a detailed individual
channel operation screen, which
shows a bargraph with relay set
points, numerical values, sensor
input, and relay status for the relays
assigned to that particular channel.
100 ft
Ch 1:
87.5
ft
Sensor In: 18.00 mA
Rly: Low: High:
2: 40.0 50.0 ON
3: 8.0 20.0 ON
H2
L2
H3
L3
0 ft
SETUP AUTO ACK NEXT SIM
SETUP Press to enter setup menu (Password restricted).
AUTO / MANUAL The AUTO key indicates the unit is in Automatic mode. Press it to
switch to Manual mode. Press NEXT to return to main screen. Once
in Manual mode press MANUAL to switch to Automatic mode.
Note: The AUTO / MANUAL modes are password restricted.
SIM / RST Press to enter a simulation mode where the input can be adjusted
manually. (Password restricted.) If the channel is set for Integration
totalizing, the SIM key is replaced by RST, which is used to reset
the total to zero (Password restricted.)
ACK Press to acknowledge (reset) the relays assigned to Supervisory,
Summary or Annunciator Alarm functions and to silence the buzzer.
NEXT Press to scroll to the next operation screen.