Solare Datensysteme Solar-Log - Manual (Page 155)

155
Direct Device Configurations (Solar-Log 1200 and 2000)
24�4�1 Initial configuration (only Solar-Log 1200)
The initial configuration is automatically started for the initial setup. However, it can also be started at any
time from the Start | Initial Configuration menu.
Procedure:
•
After the Solar-Log 1200, 2000 starts, select the system language
Fig.: Display: Initial configuration language selection
•
Enter the IP address for the Solar-Log™ in the second step.
Alternately, check obtained IP address automatically if the Solar-Log™ is connected to a router
with the DHCP service enabled.
Fig.: Display: IP address settings in the initial configuration
•
The next step refers to the interfaces of the connected devices. The Solar-Log™ inquiries about
each connected device per interface. Select the respective device or manufacturer.