Solare Datensysteme Solar-Log - Manual (Page 180)

180
Direct Device Configurations (Solar-Log 1000)
•
Touch Add to select from the inverters list, then touch Back to close the list.
•
Under Name you can change the name of the group using the virtual keyboard, then confirm with
OK.
•
In the Plant group sub dialog box, touch Back .
•
Define any other groups required in the initial dialog
•
When all groups have been defined, touch Save the initial dialog box.
26�7�1 Configuring inverter data
Inverter configuration consists of a number of sub dialog boxes, but only the first two are important for the
initial configuration.
The other settings are related to plant monitoring and graph scaling, which are already pre-set with realis-
tic values. Nothing usually needs to be changed here.
The following individual dialogs are available for inverter configuration:
•
Changing the inverter data
•
Assigning a new number (only for inverters without their own addressing function)
Changing the name
•
Entering a pulse factor (only for S0 meter)
•
Set up the SO meter (only SO meter)
•
Setting the module and power data
•
Configuring the monitoring
•
Configuring the graph display
All the dialog boxes apply only to the inverters that have been selected.
•
Select Config./Basic/Inverter from the menu
•
A dialog box opens for selecting the inverters.
•
To select an inverter, touch the corresponding Number
•
A list of the inverters available in the initial configuration is displayed.
•
Select the desired inverter, then confirm with Select.
Changing the inverter data
Note
The entries in the inverter configuration dialog boxes shown in the example can differ ac-
cording to the inverter and the interface.
The following dialog boxes can be configured:
Number
Indicates the internal position at which the inverter (or plant group) was detected.