Solare Datensysteme Solar-Log - Manual (Page 175)

175
Direct Device Configurations (Solar-Log 1000)
Procedure
•
Select Config./Start/Inverter detection from the menu.
•
Touch Start.
•
The following overview screen then appears.
All interfaces are scanned one after the other and any inverters found are listed under the predefined in-
verter types. This process can last different lengths of time depending on the inverters connected.
Note
For inverter detection, all inverters must be active. Detection cannot therefore be carried
out after dark.
•
After detection is complete, the number of inverters detected should be checked in the list. If an
inverter is missing, check the inverter setting and the wiring and repeat the detection process.
The other settings in the inverter configuration should be made only after all inverters have been
successfully detected.
If no inverters have been detected, this is also indicated on the display. In this case, the detection
process must be repeated.
Once detection has been completed successfully, you are asked whether inverter configuration is
to be carried out.
•
If all inverters have been detected,
confirm by selecting
Yes .
26�5 Changing network settings
Configuring the network settings – if this is necessary after the initial configuration – covers the following
points from the menu Basic | Network:
•
Changing the network access
•
Changing the DHCP settings
•
Settings for analog modem
•
Settings for GPRS modem
•
Solar-Log 1000 WiFi WLAN configuration (Basic/WLAN)