Solare Datensysteme Solar-Log - Manual (Page 40)

40
Connector Assignments and Wiring
10�5�2 S0 OUT IN (S0-IN A and S0-OUT)
The S0_OUT_IN interface is a hardware interface used for recording measurement values from power
meters and an output for S0 pulses. Use the supplied terminal block connector for the connection to the
Solar-Log™.
S0_OUT_IN
PIN Assignment
1 27 mA output
2 27 mA max. input
3 Measuring contact
4 Ground
5 S0 Out+
6 S0 Out-
Fig.: Schematic diagram of the S0 output
Note
We recommend not using the S0 output for sending current feed amount response sig-
nals to your grid operator.
Due to the internal calculating processes of the Solar-Log™, there would be a delay in
sending the pulses.