Solare Datensysteme Solar-Log - Manual (Page 211)

211
Faults
29�3�1 Portal Transfer Fault messages
Portal Transfer Fault messages
Error code Message Possible cause/remedy
101 The server address could
not be resolved. The access type was not configured. An
alternative DNS server is required. The wrong
server was entered. The network connection
was disconnected and could not be reestab-
lished.
102 Cannot open socket. Possible causes: Unknown. If this error contin-
ues to occur, contact our technical support.
103 Cannot connect to socket. Possible causes: The connection is blocked by
a firewall or a router. The wrong server was
entered. The server is offline.
104 and 106 Connection error. This can occasionally happen with GPRS con-
nections. Try it again. The network cable has
a loose connection. There are problems with
your Internet connection.
220 Authentication failure
(portal). The portal registration was done incorrectly.
The portal was not configured for HTTP
transfers. The wrong server was entered.
222 Connection to server
successful but no answer
received to the inquiry. Check the entered portal server name.
This can happen occasionally to GPRS con-
nections. Simply try again.
Other General errors. There is detailed description of this error.
If this error continues to occur, contact our
technical support.
.
29�3�2 Fault messages Feed-in Management
These fault messages are displayed on the LCD display.
The percentage symbol blinks and the corresponding error code is displayed.
Fault messages
Feed-in Management
Error code Possible cause/remedy
1 Undefined status for the PM+ interface or an invalid channel setting
for the active and reactive power management.
=> Check the wiring and configuration.
2 Communication error with the I/O Box
=> Check the wiring and the power supply for the I/O Box.
=> Check the interface selected under Configuration | Special Func-
tions | Feed-in Management | Profile.