Solare Datensysteme Solar-Log - Manual (Page 202)

202
Faults
Restarting
Press the reset button with a paper clip or similar pointed object
•
The Solar-Log™ beeps and the following is displayed on the LCD:
•
After about 5 seconds, the Solar-Log™ beeps three times and the following is displayed:
•
Now release the button, the following is then displayed
•
The Solar-Log™ reboots itself.
Under no circumstances should the power plug simply be disconnected. Do not restart by pulling out the
power plug!
29�1�3 Restoring the factory settings
Restoring the factory settings is necessary if Solar-Log™ is to be used on another system or if an incorrect
configuration is being deleted.
All settings made on the unit are lost, as well as all data collected during run-time. It is therefore advisable
to back up the data before resetting:
•
System (See Chapter 21.3),
•
Data (See Chapter 21.4);
Status after restoring factory settings
Time: Retained
IP address: Retained with Solar-Log 1200 and 2000, DHCP active with Solar-Log 300
Passwords: Deleted
Configuration data: Deleted
Yield data: Deleted