PLANET ICA-HM620 - Manual (Page 63)

Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take when motion is detected. All options are listed
as follows:
• Enable Alarm Output 1/2
Check the item and select the predefined type of alarm output to enable alarm relay output when
motion is detected.
• Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP and/or E-Mail when motion is
detected.
• Upload Image by FTP
Select this item, and the Administrator can assign a FTP site and configure various parameters as
shown in the figure below. When motion is detected, event images will be uploaded to the appointed
FTP site.
• Upload Image by E-Mail
Select this item, and the Administrator can assign an e-mail address and configure various parameters
as shown in the figure below. When motion is detected, event images will be sent to the appointed
e-mail address.
Note
Make sure SMTP or FTP configuration has been completed. See section Mail and FTP for
further details.
- 63 -