PLANET ICA-HM620 - Manual (Page 85)

4.5 PTZ Settings
Under the tab <PTZ>, there are categories including: <Preset>, <Cruise>, <Auto
Pan>, <Sequence>, <Home>, <Tilt Range>, <Camera- Exposure>, <Camera- WB>,
<Camera- Misc1>, <Camera- Misc2>, and <Camera- Default>.
4.5.1 Preset
The Preset Programming can be found under this path: PTZ> Preset.
Totally 256 Preset Points can be programmed for the Speed Dome IP Camera. Please refer to the
instructions below to set a Preset Point.
Preset Setting
To setup a Preset Point, please first move the cursor to the live view pane. Then left click and drag the
red pointer with PTZ controls to a desired position and adjust the fine zoom/ focus ratio. Subsequently,
assign a number for the current position from the drop-down Number List, and enter its descriptive
name. Click on the button <Set> to save the settings mentioned above.
Preset Go
To have the camera move to a specified Preset position, please select the Preset Point from the
drop-down Presetlist. Then the camera shall readily move to the target position.
4.5.2 Cruise
The Cruise Programming can be found under this path: PTZ> Cruise.
The Speed Dome IP Camera supports up to eight Cruise Paths. Please follow the instructions below for
Cruise Path setup.
- 85 -