PLANET ICA-HM620 - Manual (Page 66)

Pre-trigger buffer recording function allows users to check what happened to cause the trigger. The
pre-trigger buffer time range is from 1 to 3 seconds. Select <Upload for __ sec> to set the recording
duration after alarm is triggered. The setting range is from 1 to 99999 seconds. Select <Upload during
the trigger active> to record the triggered video until the trigger is off.
Note
Please make sure the local recording (with Micro SD/ SDHC card) is activated so that this
function can be implemented. Refer to Recording for further details.
• Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP and/or E-Mail when tampering
is detected.
• Upload Image by FTP
Select this item and the Administrator can assign a FTP site and configure various parameters. When
tampering is detected, event images will be uploaded to the appointed FTP site.
• Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and configure various parameters.
When tampering is detected, event images will be sent to the appointed e-mail address.
Note
Make sure SMTP or FTP configuration has been completed. Refer to Mail and FTP for
further details.
• Send HTTP notification
Check this item, select the destination HTTP address, and specify the parameters for HTTP
notifications. When the Tampering Alarm is triggered, the HTTP notifications can be sent to the
specified HTTP server.
For instance, if the custom parameter is set as” action=1&group=2”, and the HTTP server name is”
http://192.168.0.1/admin.php”, the notification will be sent to HTTP server as”
http://192.168.0.1/admin.php? action=1&group=2” when alarm is triggered.
4.3.11 Storage Management (Local Recording)
The Storage Management setting can be found under this path: System> Storage Management.
- 66 -