Canon EOS 80D - Manual (Page 423)

423
3 Custom Function SettingsN
C.Fn II -13 AF point selection pattern
During manual AF point selection, the selection can either stop at the
outer edge or it can cycle around to the opposite side.
This works with any AF area selection mode other than 45-point
automatic selection AF (with AI Servo AF enabled).
0: Stops at AF area edges
Useful if you often use an AF point along the edge.
1: Continuous
Instead of stopping at the outer edge, the selection of AF point
continues to the opposite side.
C.Fn II -14 AF point display during focus
You can set whether or not to display the AF point(s) in the following
cases: 1. when selecting the AF point(s), 2. when the camera is ready
to shoot (before AF operation), 3. during AF operation, and 4. when
focus is achieved.
0: Selected (constant)
The selected AF point(s) is always displayed.
1: All (constant)
All the AF points are always displayed.
2: Selected (pre-AF, focused)
The selected AF point(s) is displayed for 1, 2, and 4.
3: Selected (focused)
The selected AF point(s) is displayed for 1 and 4.
4: Disable display
For 2, 3, and 4, the selected AF point(s) will not be displayed.
 With setting [0: Enable], focusing will take slightly longer than with
setting [1: Disable].
 Even with setting [0: Enable], the expected result may not be obtained
depending on the shooting conditions and subject.
 Under light so low that the flash emits the AF-assist beam automatically,
AF points are selected automatically based only on AF information. (The
AF will not use information on colors equivalent to skin tones.)
If [2: Selected (pre-AF, focused)] or [3: Selected (focused)] is set, the AF
point will not be displayed even when focus is achieved with AI Servo AF.